Comparison between the sliding mesh model and the momentum source model for the numerical simulation of the working principle of mixing tanks

Authors

  • Laísa Luiz Soares Federal University of Rio Grande
  • Marcelo Moraes Galarça Federal Institute of Rio Grande do Su
  • Elizaldo Domingues dos Santos Federal University of Rio Grande
  • João Américo Aguirre Oliveira Júnior ESSS Ltda.

DOI:

https://doi.org/10.14808/sci.plena.2019.049907

Keywords:

Numerical simulation, stirred tank, numerical model.

Abstract

In this paper the aims to present a comparison between two numerical models capable of simulating the working principle of mixing tanks, which are used in several chemical industries, among them, for the production of biodiesel. The objective is to make a comparison between the results obtained with these models and the results found in the literature, in order to show the predictive capacity of the models developed and the computational effort of each of them. The numerical simulations were performed using FLUENT software, based on the Finite Volume Method (FVM). The comparison of the results between the present paper and the data found in the literature was performed from the prediction of the velocity fields monitored in the flow. In general, a good agreement was found between the results of the present paper and the literature results, in relation to the flow behavior, at certain points that were analyzed inside the tank. It was also certified a large difference in time and computational effort between the two numerical models.

Author Biographies

Laísa Luiz Soares, Federal University of Rio Grande

http://lattes.cnpq.br/7189312741707458

Marcelo Moraes Galarça, Federal Institute of Rio Grande do Su

http://lattes.cnpq.br/1660157566796755

Elizaldo Domingues dos Santos, Federal University of Rio Grande

http://lattes.cnpq.br/6854950768271660

João Américo Aguirre Oliveira Júnior, ESSS Ltda.

http://lattes.cnpq.br/3863567425783113

Published

2019-06-03

How to Cite

Soares, L. L., Galarça, M. M., dos Santos, E. D., & Oliveira Júnior, J. A. A. (2019). Comparison between the sliding mesh model and the momentum source model for the numerical simulation of the working principle of mixing tanks. Scientia Plena, 15(4). https://doi.org/10.14808/sci.plena.2019.049907

Issue

Section

VIII Conferência Sul Modelagem Computacional/VIII Seminário Workshop Engenharia

Most read articles by the same author(s)

<< < 1 2 3